Mazda 6 Owners Manual: Ventilation
1. Set the mode selector dial to the
position.
2. Set the air intake selector to the outside air position (indicator light turns off).
3. Set the temperature control dial to the desired position.
4. Set the fan control dial to the desired speed.
Cooling (With air conditioner)
1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the cold position.
3. Set the fan control dial to the desired speed.
4. Turn on the air conditioner by pressi ...
Windshield Defrosting and Defogging
1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the desired position.
3. Set the fan control dial to the desired speed.
4. If dehumidified heating is desired ...
Other materials:
Mazda 6 Owners Manual: After repair procedure
Caution
After repairing a malfunction, perform this procedure to verify that the
malfunction has been corrected.
When this procedure is carried out, be sure to drive the vehicle at lawful
speed and pay attention to the other vehicles.
1. Connect the WDS or equivalent to the DLC-2.
2. Turn th ...
Mazda 6 Owners Manual: Rear door garnish installation
Note
Double-sided adhesive tape has already been attached to the new
rear door garnish.
Warning
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
1. When installing a new rear door garnish, follow the procedure below:
(1) Remove the adhesi ...