Mazda 6 Service Manual: Ashtray illumination bulb removal/installation
1. Disconnect the negative battery cable.
2. Remove the boot panel.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Door switch inspection
1. Remove the door switch. (See DOOR SWITCH REMOVAL/INSTALLATION)
2. Inspect for continuity between the door switch terminal and a body ground
using an ohmmeter.
If not as specified, replace th ...
Ignition key illumination bulb removal/installation
1. Disconnect the negative battery cable.
2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
3. Remove the ignition key illumination bulb.
4. Install in the reverse order of remo ...
Other materials:
Mazda 6 Service Manual: Clutch fluid replacement
Caution
Be careful not to spill clutch fluid on a painted surface. If this
should happen, wash it off immediately.
Note
Do not mix different brands of clutch fluid.
Do not reuse the clutch fluid that was drained out.
1. Remove the under cover.
2. Draw the fluid from the reservoir ...
Mazda 6 Service Manual: Engine coolant temperature (ect) sensor removal/installation
Warning
When the engine is hot, it can badly burn. Turn off the engine and
wait until it is cool before removing the ECT sensor.
1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
2. Disconnect the ECT sensor connector.
3. Remove the ECT sensor.
4. Install in the reve ...