Mazda 6 Service Manual: Automatic transaxle on-board diagnostic function
DTC Reading Procedure
(See ON-BOARD DIAGNOSTIC TEST.)
Foreword
When the customer reports a vehicle malfunction, check the malfunction
indicator lamp (MIL), HOLD indicator light flashing, and PCM memory for
diagnostic trouble code (DTC), then diagnose the ...
After repair procedure
Caution
After repairing a malfunction, perform this procedure to verify that the
malfunction has been corrected.
When this procedure is carried out, be sure to drive the vehicle at lawful
speed ...
Other materials:
Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over.
2. Disengage clips A using a fastener remover.
3. Pull the A-pillar trim, then disengage clip B (1).
4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar
trim (2).
5. Pull clip B out, then rotate 45°.
6. Remove clip B from the grommet b ...
Mazda 6 Service Manual: Wheel hub bolt replacement
1. Remove the hub bolt using the SSTs.
Note
If the dust cover interferes with the wheel hub bolt and the wheel
hub bolt cannot be removed, tap the part shown in the figure with a chisel
lightly and bend the processing point back to the steering knuckle side.
2. Install the hub bolt i ...