Mazda 6 Service Manual: Bonnet switch inspection
Note
- Bonnet switch has a built-in bonnet lock.
1. Open the bonnet.
2. Disconnect the negative battery cable.
3. Remove the radiator grille.
4. Disconnect the bonnet switch connector.
5. Check the continuity between the bonnet switch terminals A and B using an ohmmeter.
- If there is continuity, replace the bonnet switch.
6. Lock the bonnet lock using a flat-head screwdriver or equivalent as shown.
7. Check the no continuity between the bonnet switch terminals A and B using an ohmmeter.
- If there is no continuity, replace the bonnet switch.
Caution
- After the inspection, unlock the bonnet lock. If closing the bonnet with the bonnet lock locked, the bonnet lock and/or bonnet striker may be broken.
Theft-deterrent control module removal/installation
1. Disconnect the negative battery cable.
2. Remove the center panel module. (See CENTER PANEL MODULE
REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the r ...
Other materials:
Mazda 6 Service Manual: Operating Tips for OGG
OGG is the audio compression format for Xiph. Org Foundation.
Audio data can be created and stored at a higher compression ratio than MP3.
This unit plays files with the extension (.ogg) as OGG files.
CAUTION
Do not use an audio file extension on files other than audio files. In addition,
do n ...
Mazda 6 Service Manual: Stopping The Smart Brake Support (SBS) System Operation
The Smart Brake Support (SBS) system can be temporarily deactivated.
When the Smart Brake Support (SBS) system is turned off, the Smart Brake Support
(SBS) OFF indicator light turns on.
When the engine is restarted, the system becomes operational.
NOTE
If the Smart Brake Support (SBS) system ...