Mazda 6 Service Manual: Theft-deterrent system

Information display removal/installation

1. Disconnect the negative battery cable. 2. Remove the center panel module. (See CENTER PANEL MODULE REMOVAL/INSTALLATION.) 3. Remove the LCD unit. (with car-navigation system) (See LCD UNIT RE ...

Bonnet switch inspection

Note Bonnet switch has a built-in bonnet lock. 1. Open the bonnet. 2. Disconnect the negative battery cable. 3. Remove the radiator grille. 4. Disconnect the bonnet switch connector. 5. Che ...

Other materials:

Mazda 6 Service Manual: Dynamometer
When inspecting and servicing the power train on the dynamometer or speed meter tester, pay attention to the following: - Place a fan, preferably a vehicle-speed proportional type, in front of the vehicle. - Make sure the vehicle is in a facility with an exhaust gas ventilation ...

Mazda 6 Service Manual: No.8 brake system warning light stays on more than 4 seconds with ignition switch on
Diagnostic procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure co ...