Mazda 6 Service Manual: Center panel module removal/installation
1. Cancel the anti-theft operation. (with anti-theft system) (See ANTI-THEFT SYSTEM.)
2. Disconnect the negative battery cable.
3. Remove the glove compartment.
4. Remove the rear console.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
Caution
- Make certain that the wiring harness and antenna feeder are not caught between the unit and dashboard. If the harness or the antenna feeder is caught between the unit and dashboard, it may cause trouble or malfunctions.
7. Operate the anti-theft system by setting the code number. (with anti-theft system) (See ANTI-THEFT SYSTEM.)
Center Panel Module Removal Note
Pull the center panel module toward you, then disengage clip A from the dashboard, and remove the center panel module.
Anti-theft system
Alarm Conditions
If the anti-theft system protection has been activated, any one of the
following conditions will trigger the system:
- Disconnected battery cable
- Discharged battery
...
Center panel module disassembly/assembly
Caution
Before disassembling the center panel module, spread a cloth on the floor to
put the disassembled parts on. This protects the surface of the panel from
scratches or dirt.
1. Remove ...
Other materials:
Mazda 6 Service Manual: Rear seat removal/installation
4SD
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
5HB
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Remote wire removal note
1. Turn over the trunk floor mat.
2. Remove the case.
3. Remove the ...
Mazda 6 Service Manual: Pre-delivery inspection
PRE-DELIVERY INSPECTION TABLE EXTERIOR
INSPECT and ADJUST, if necessary, the following items to
specification:
- Glass, exterior bright metal and paint for damage
- All weatherstrips for damage or detachment
- Door operation and alignment including side door and back door
- Wheel lug nu ...