Mazda 6 Service Manual: Climate control unit installation
1. Pass each wire through the following routes then connect to A/C unit. (Manual air conditioner)
2. Connect the climate control unit connectors. (Manual air conditioner)
3. Install the climate control unit to the center panel. (Full-auto air conditioner)
4. Install the center panel.
5. Adjust the climate control unit wires. (Manual air conditioner) (See CLIMATE CONTROL UNIT WIRE ADJUSTMENT.)
6. Connect the negative battery cable.
Climate control unit removal
1. Disconnect the negative battery cable.
2. Disconnect the air mix and airflow mode wires from each wire clamp and
link. (Manual air conditioner)
3. Remove the center panel. (See CENTER PANEL MOD ...
Climate control unit disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Wire Disassembly Note
Disassemble the wires in the shown in the figure.
Wire Assembly ...
Other materials:
Mazda 6 Service Manual: Abs (abs/tcs) hu/cm system inspection
System Inspection
Preparation
1. Verify that the battery is fully charged. With the ignition switch on,
verify that the ABS and BRAKE system warning lights goes out after 2.4
seconds.
2. If the lights stays on after 2.4 seconds, the ABS (ABS/TCS) HU/CM
detects a failure. Follow the troubles ...
Mazda 6 Service Manual: Drive shaft (mtx) disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Clip Disassembly Note
1. Mark the drive shaft and outer ring for proper assembly.
Caution
Mark with paint; do not use a punch.
2. Remove the clip.
Balls, Inner Ring, Cage Disassembl ...