Mazda 6 Service Manual: Control system

Refrigerant lines removal/installation

1. Remove the battery. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the washer tank. (L.H.D. only) (See WASHER TANK REMOVAL/INSTALLATION.) 4. Remove the ...

Air intake actuator removal/installation

1. Disconnect the negative battery cable. 2. Remove the glove compartment. 3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.) 4. Remove in the order indicated in t ...

Other materials:

Mazda 6 Service Manual: Transaxle range (tr) switch inspection
Operating Inspection 1. Verify that the starter operates only when the ignition switch is at the START position with the selector lever in P or N position. If not as specified, adjust the TR switch. 2. Verify that the back-up lights illuminate when shifted to R position with the ignition ...

Mazda 6 Service Manual: Trunk side trim removal/installation
4SD 1. Remove the trunk end trim. 2. Remove the fasteners, then remove the trunk side trim. 3. Install in the reverse order of removal. 5HB 1. Remove the trunk end trim. 2. Remove the trunk side upper trim. 3. Remove the cargo hooks. 4. Remove the fasteners. 5. Pull the trunk side trim ...