Mazda 6 Service Manual: Airflow mode actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the airflow mode actuator.
2. Verify that the airflow mode actuator operates as shown below.
- If not as specified, replace the airflow mode actuator.
3. Verify that the resistance between the terminals of the airflow mode actuator is as shown in the graph.
- If not as specified, replace the airflow mode actuator.
Airflow mode actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT
REMOVAL/INSTALLATION.)
4. Remove in the order indicated in t ...
Blower motor removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Contact Authorized Mazda Dealer and Have Vehicle Inspected
If any of the following warning lights or the indicator light turns on/flashes,
the system may have a malfunction. Contact an Authorized Mazda Dealer to have your
vehicle inspected.
...
Mazda 6 Service Manual: Operating Tips for WMA
WMA is short for Windows Media*1 Audio and is the audio compression format used
by Microsoft*1.
Audio data can be created and stored at a higher compression ratio than MP3.
This unit plays files with the extension (.wma) as WMA files.
*1 Windows Media and Microsoft are registered trademarks of ...