Mazda 6 Service Manual: Resistor inspection
Verify that the resistance between the terminals of the resistor is as shown in the table.
- If not as specified, replace the resistor.
POWER MOS FET REMOVAL/INSTALLATION
(See RESISTOR REMOVAL/INSTALLATION.)
Resistor removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT
REMOVAL/INSTALLATION.)
4. Remove in the order indicated in t ...
Power mos fet inspection
Verify that the resistance between the terminals of the power MOS FET is as
shown in the table.
If not as specified, replace the power MOS FET.
...
Other materials:
Mazda 6 Service Manual: Removing a Flat Tire
1. Loosen the lug nuts by turning them counterclockwise one turn each, but do
not remove any lug nuts until the tire has been raised off the ground.
2. Place the jack on the ground.
3. Turn the jack screw in the direction shown in the figure and adjust the jack
head so that it is close to th ...
Mazda 6 Service Manual: Outside Temperature Display (Without Multi-information Display)
When the ignition is switched ON, the outside temperature is displayed.
NOTE
Under the following conditions, the outside temperature display may differ
from the actual outside temperature depending on the surroundings and vehicle conditions:
Significantly cold or hot temperatures.
Sudden ...