Mazda 6 Owners Manual: Closing the Hood
1. Check under the hood area to make certain all filler caps are in place and all loose items (e.g. tools, oil containers, etc.) have been removed.
2. Lift the hood, grasp the padded area on the support rod, and secure the support rod in the clip. Verify that the support rod is secured in the clip before closing the hood.
3. Lower the hood slowly to a height of about 20 cm (7.9 in) above its closed position and then let it drop.
CAUTION
When closing the hood, do not push it excessively such as by applying your weight. Otherwise, the hood could be deformed.
Opening the Hood
1. With the vehicle parked, pull the release handle to unlock the hood.
2. Insert your hand into the hood opening, slide the latch lever to the right,
and lift up the hood.
NOTE
The lever is ...
Other materials:
Mazda 6 Owners Manual: Refrigerant pressure switch inspection
1. Install the SST (gas charging set).
2. Disconnect the refrigerant pressure switch connector.
3. Verify the high-pressure side reading of the SST (manifold gauge)
and continuity between the terminals of the refrigerant pressure switch.
If not as specified, replace the refrigerant pressure ...
Mazda 6 Owners Manual: Oil pressure switch inspection
1. Verify that the oil pressure warning light illuminates when the ignition
switch is at ON position.
2. Verify that the oil pressure warning light goes off when the engine is
started.
If the oil pressure warning light does not illuminate or remains
illuminated, inspect the related wirin ...