Mazda 6 Service Manual: Clutch release cylinder disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Clutch release cylinder removal/installation
1. Remove the under cover.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
...
Clutch unit
...
Other materials:
Mazda 6 Service Manual: Oil cooler flushing
Note
The contaminated cooler line (oil pipes and hoses) and auxiliary
cooler must be flushed completely when ATX is overhauled or replaced.
1. Remove the two oil cooler line hoses and apply air pressure of 196 kPa
{2.0 kgf/cm2, 28 psi} from the return hose (pipe) side.
Caution
Power ...
Mazda 6 Service Manual: Side protector removal
1. Pry the side protector end 20-30 mm {0.8-1.1 in} using a flathead
screwdriver or a razor.
Warning
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
Note
The side protector is installed with double-sided adhesive tape.
If the side protector ...