Mazda 6 Service Manual: Coil removal/installation
Note
- Do not remove the coil unless you are replacing it.
- When only the coil is replaced, the immobilizer system reprogram procedure is not necessary.
1. Disconnect the negative battery cable.
2. Remove the column cover.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Immobilizer system reprogram procedure
Note
When an error occurs during the reprogram procedures, except when
the PCM is replaced, repeat the procedure from Step 1. If you still cannot
reprogram, confirm how many keys can start t ...
Other materials:
Mazda 6 Service Manual: Gate operator/Canadian Programming
Canadian radio-frequency laws require transmitter signals to “time-out” (or quit)
after several seconds of transmission — which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this Canadian law, some U.S.
gate operators are designed to “time-out ...
Mazda 6 Service Manual: Parking in an Emergency
The hazard warning lights should always be used when you stop on or near a roadway
in an emergency.
The hazard warning lights warn other drivers that your vehicle is a traffic hazard
and that they must take extreme caution when near it.
Depress the hazard warning flasher and all the turn s ...