Mazda 6 Service Manual: Cooling system service warnings
COOLING SYSTEM SERVICE WARNINGS
Warning
- Never remove the radiator cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system.
- Turn off the engine and wait until it is cool. Even then, be very
careful when removing the cap.
Wrap a thick cloth around it and slowly turn it counterclockwise to the first stop. Step back while the pressure escapes.
- When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.
Location index
...
Engine coolant
ENGINE COOLANT LEVEL INSPECTION
Verify that the coolant level in the coolant reservoir is between the F and L
marks.
If the engine coolant level is below L, remove the radiator cap and add
c ...
Other materials:
Mazda 6 Service Manual: Refrigerant pressure switch inspection
1. Install the SST (gas charging set).
2. Disconnect the refrigerant pressure switch connector.
3. Verify the high-pressure side reading of the SST (manifold gauge)
and continuity between the terminals of the refrigerant pressure switch.
If not as specified, replace the refrigerant pressure ...
Mazda 6 Service Manual: Sunroof motor inspection
Motor
1. Remove the sunroof motor.
2. Apply battery positive voltage to the sunroof motor terminals and inspect
the operation of the sunroof motor.
If not as specified, replace the sunroof motor.
Limit Switch
1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.)
2. Verify t ...