Mazda 6 Service Manual: Instrument cluster repair
Note
- The needle of speedometer or tachometer may continue to rotate clockwise until it indicates over maximum graduation. If a customer complains of this concern, repair the needle position according to the following steps.
1. Verify the concern.
2. Turn the ignition switch to LOCK position.
3. Disconnect the negative battery cable.
4. Connect the negative battery cable.
5. Turn the ignition switch to ON position.
6. Verify that the needle returns to zero.
- If the needle does not return to zero, replace the instrument cluster
Instrument cluster inspection
Speedometer
Using the input/output check mode
Inspect the speedometer by setting it in the input/output check mode DTC 12.
Using a speedometer tester
1. Adjust the tire air pressure to the specifi ...
Instrument cluster input/output check mode
Note
In this mode, it is possible to check the items in the following
chart.
Diagnostic Trouble Code Chart
Note
Diagnostic trouble codes which are not listed may be indicated,
but ...
Other materials:
Mazda 6 Service Manual: To Decrease Cruising Speed
Press the SET/ switch and hold
it. The vehicle will gradually slow.
Release the switch at the desired speed.
Press the SET/ switch and release
it immediately to adjust the preset speed.
Multiple operations will decrease the preset speed according to the number of
times it is operated.
Decr ...
Mazda 6 Service Manual: Rear door trim removal/installation
1. Disconnect the negative battery cable if equipped with power window
system.
2. Remove the regulator handle if equipped.
3. Open the cap using a small screwdriver, then remove the screw.
4. Remove the inner handle cover.
5. Remove the cover, then remove screw.
6. Disengage clips A from th ...