Mazda 6 Service Manual: Instrument cluster input/output check mode
Note
- In this mode, it is possible to check the items in the following
chart.
Diagnostic Trouble Code Chart
Note
- Diagnostic trouble codes which are not listed may be indicated,
but they cannot be inspected.
- The diagnostic trouble codes are displayed in numerical order.
(While performing the inspection, if you want to inspect a diagnostic
trouble code of which the number is smaller than the code number you are
currently inspecting, terminate the check mode then repeat the inspection
from the beginning.)
- If the speed signal is put into the instrument cluster (the front
wheels are rotated) while a code other than DTC 00 is display, the
input/output check mode will be cancelled.
- The diagnostic trouble codes can be fast-forwarded by pushing and
holding the odometer/tripmeter switch for 1 second or more.
Operating Order
Checking Order
Note
- When inspecting more than two DTCs, perform the inspection by
following the priority order of inspection indicated in the chart below.
Inspection of Diagnostic Trouble Codes
Diagnostic procedure
Diagnostic procedure
Diagnostic procedure
Diagnostic procedure
Diagnostic procedure
Diagnostic procedure
Note
The needle of speedometer or tachometer may continue to rotate
clockwise until it indicates over maximum graduation. If a customer
complains of this concern, repair the needle position ...
1. Connect SST (WDS or equivalent) to the vehicle DLC-2 16-pin
connector.
2. Access and monitor PIDs using SST (WDS or equivalent).
Monitor Item Table
The PID/DATA monitoring items for the i ...
Other materials:
Mazda 6 Service Manual: Heated Steering Wheel (Some models)
The grips on the left and right of the steering wheel can be warmed up.
The ignition must be switched ON.
Press the switch to turn on the heated steering wheel. The heated steering wheel
operates for about 30 minutes and then turns off automatically.
The indicator light illuminates when the h ...
Mazda 6 Service Manual: Removing a Flat Tire
1. Loosen the lug nuts by turning them counterclockwise one turn each, but do
not remove any lug nuts until the tire has been raised off the ground.
2. Place the jack on the ground.
3. Turn the jack screw in the direction shown in the figure and adjust the jack
head so that it is close to th ...