Mazda 6 Service Manual: Pid/data monitor and record procedure
1. Connect SST
(WDS or equivalent) to the vehicle DLC-2 16-pin connector.
2. Access and monitor PIDs using SST
(WDS or equivalent).
Monitor Item Table
- The PID/DATA monitoring items for the instrument cluster is as shown in the table below.
Instrument cluster input/output check mode
Note
In this mode, it is possible to check the items in the following
chart.
Diagnostic Trouble Code Chart
Note
Diagnostic trouble codes which are not listed may be indicated,
but ...
Fuel gauge sender unit inspection
Move the float to the topmost and bottommost positions, and verify that the
resistance between terminals A and B of the unit and the position of the float
are as indicated in the figure.
If th ...
Other materials:
Mazda 6 Service Manual: Heating
1. Set the mode selector dial to the
position.
2. Set the air intake selector to the outside air position (indicator light turns
off).
3. Set the temperature control dial to the hot position.
4. Set the fan control dial to the desired speed.
5. If dehumidified heating is desired, turn on the ...
Mazda 6 Service Manual: Scheduled Maintenance (U.S.A., Canada, and Puerto Rico)
Follow Schedule 1 if the vehicle is operated mainly where none of the following
conditions (severe driving conditions) apply.
Repeated short-distance driving
Driving in dusty conditions
Driving with extended use of brakes
Driving in areas where salt or other corrosive materials are used
...