Mazda 6 Owners Manual: Heating
1. Set the mode selector dial to the
position.
2. Set the air intake selector to the outside air position (indicator light turns off).
3. Set the temperature control dial to the hot position.
4. Set the fan control dial to the desired speed.
5. If dehumidified heating is desired, turn on the air conditioner.
NOTE
- If the windshield fogs up easily, set the mode selector dial to the
position. - If cooler air is desired at face level, set the mode selector dial at
the
position and adjust the
temperature control dial to maintain maximum comfort. - The air to the floor is warmer than air to the face (except when the temperature control dial is set at the extreme hot or cold position).
Control Switches
Temperature control dial
This dial controls temperature. Turn it clockwise for hot and counterclockwise
for cold.
NOTE
When the mode is set to or
with the fan control dial in a
position othe ...
Cooling (With air conditioner)
1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the cold position.
3. Set the fan control dial to the desired speed.
4. Turn on the air conditioner by pressi ...
Other materials:
Mazda 6 Owners Manual: Using Automatic Locking Mode (Some models)
Follow these instructions when using a child-restraint system, unless you are
attaching a LATCH-equipped childrestraint system to the rear LATCH lower anchors.
Refer to “Using LATCH Lower Anchor”.
NOTE
Follow the child-restraint system manufacturer's instructions carefully. If
you are no ...
Mazda 6 Owners Manual: Oil pan
OIL PAN REMOVAL/INSTALLATION
Warning
Hot engine and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine oil have cooled.
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Drain the engine oil. (See ENGINE OIL REPLACEMENT.)
4. Re ...