Mazda 6 Service Manual: Fuel gauge sender unit inspection
Move the float to the topmost and bottommost positions, and verify that the resistance between terminals A and B of the unit and the position of the float are as indicated in the figure.
- If they are not as indicated, replace the fuel gauge sender unit.
Pid/data monitor and record procedure
1. Connect SST (WDS or equivalent) to the vehicle DLC-2 16-pin
connector.
2. Access and monitor PIDs using SST (WDS or equivalent).
Monitor Item Table
The PID/DATA monitoring items for the i ...
Oil pressure switch inspection
1. Verify that the oil pressure warning light illuminates when the ignition
switch is at ON position.
2. Verify that the oil pressure warning light goes off when the engine is
started.
If the ...
Other materials:
Mazda 6 Service Manual: Front shock absorber inspection
1. Remove the front shock absorber from the vehicle.
2. Inspect for damage and oil leakage.
3. Inspect the rubber bushing for deterioration and wear.
4. Compress and extend the shock piston at least three times. Verify that the
operational force does not change and that there is no unusual nois ...
Mazda 6 Service Manual: Power Windows
The ignition must be switched ON for the power windows to operate.
WARNING
Make sure the opening is clear before closing a window: Closing a
power window is dangerous. A person's hands, head, or even neck could be caught
by the window and result in serious injury or even death. This warning ap ...