Mazda 6 Service Manual: Front shock absorber inspection
1. Remove the front shock absorber from the vehicle.
2. Inspect for damage and oil leakage.
3. Inspect the rubber bushing for deterioration and wear.
4. Compress and extend the shock piston at least three times. Verify that the operational force does not change and that there is no unusual noise.
- If not as specified, replace the shock absorber.
(1) Compress the shock absorber piston and release it.
(2) Verify that the piston extends fully at a normal speed.
Front shock absorber and spring removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing ...
Front shock absorber disposal
Warning
Whenever drilling into a shock absorber, wear protective eye wear.
The gas in the shock absorber is pressurized, and could spray metal chips
into the eyes and face when drilling.
...
Other materials:
Mazda 6 Service Manual: Road test
Warning
When performing a road test, be aware of other vehicles, people,
impediments, etc. to avoid an accident.
Note
When the legal speed limit must be exceeded, use a chassis
dynamomenter instead of performing a road test.
Road Test Preparation
1. Inspect the engine coolant le ...
Mazda 6 Service Manual: Audio control switch removal/installation
Note
The audio control switch and the cruise control switch use a
common connector.
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION.)
3. Remove the steering wheel.
4. Remove in the order indicated ...