Mazda 6 Service Manual: Dtc b1342

Mazda 6 Service Manual / Braking system / On-board diagnostic (dynamic stability control) / Dtc b1342

Caution

When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used.

Diagnostic procedure

Dtc b1318

Caution When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used. Diagnostic procedure ...

Dtc b1483, b1484, b1486

Caution When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used. Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Obd drive mode
Performing the Drive Mode inspects the OBD system for proper operation. The Drive Mode must be performed to ensure that no additional DTCs are present. During Drive Mode, the following systems are inspected: - Oxygen sensor (HO2S) - Oxygen sensor heater - Catalytic converter (TW ...

Mazda 6 Service Manual: Pcm inspection
Note PIDs for the following parts are not available on this model. Go to the appropriate part inspection page. - CMP sensor (See CAMSHAFT POSITION (CMP) SENSOR INSPECTION.) - Main relay (See RELAY INSPECTION.) 1. Connect the SST (WDS or equivalent) to the DLC-2. 2. Turn the igni ...