Mazda 6 Service Manual: Variable intake-air system (vis) shutter valve actuator inspection (l3)
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
2. Disconnect the vacuum hose from the VIS shutter valve actuator.
3. Connect a vacuum pump to the VIS shutter valve actuator.
4. Apply vacuum and verify that the rod moves.
- If the rod dose not move, replace the intake manifold.
Idle air control (iac) valve inspection
Note
Perform the following inspection only when directed.
Operation Test
Carry out the Idle Air Control Inspection. (See Idle Air Control System
Inspection.)
If not as specified, perform ...
Variable intake-air system (vis) control solenoid valve inspection (l3)
1. Remove the VIS control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the VIS ...
Other materials:
Mazda 6 Service Manual: Add-On Non-Genuine Parts and Accessories
Non-genuine parts and accessories for Mazda vehicles can be found in stores.
These may fit your vehicle, but they are not approved by Mazda for use with Mazda
vehicles. When you install non-genuine parts or accessories, they could affect your
vehicle's performance or safety systems; the Mazda w ...
Mazda 6 Service Manual: Installation of radio system
If a radio system is installed improperly or if a high-powered type is used,
the CIS and other systems may be affected. When the vehicle is to be equipped
with a radio, observe the following precautions:
Install the antenna at the farthest point from control modules.
Install the antenna fe ...