Mazda 6 Service Manual: Dtc clearing procedure
1. Start the on-board diagnostic test mode.
2. First press the POWER button, then simultaneously press AUDIO CONT button for 2 seconds or more.
Caution
- Before clearing the DTCs, be sure to enter all of them displayed in the on-board diagnostic test mode in the Audio Repair Order Form.
3. To stop the on-board diagnostic test mode, turn the ignition switch to the LOCK position.
Supplier identification procedure
Note
When asking the supplier (service center) for repair or
replacement, verify which supplier the module belongs to and enter in the
Audio Repair Order Form.
Identification With Printed ...
Dtc table
*1,*2 : When an error occurs, the error messages are displayed three times in
the order of *1 and *2, respectively. ...
Other materials:
Mazda 6 Service Manual: Steps for Determining the Correct Load Limit
Steps for Determining Correct Load Limit-
1. Locate the statement “The combined weight of occupants and cargo should never
exceed XXX kg or XXX lbs.” on your vehicle's placard.
2. Determine the combined weight of the driver and passengers that will be riding
in your vehicle.
3. Subtract t ...
Mazda 6 Service Manual: Rear crossmember removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...