Mazda 6 Service Manual: Dtc confirmation procedure

Diagnostic monitoring test results

The purpose of this test mode is to confirm the result of OBD monitor diagnostic test results. The result values stored when particular monitor is completed are displayed. If the monitor is not ...

Koeo/koer self-test

1. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 2. Perform KOEO/KOER self-test. ...

Other materials:

Mazda 6 Service Manual: Rear Window Defogger
The rear window defogger clears fog from the rear window. The ignition must be switched ON to use the defogger. Press the switch to turn on the rear window defogger. The rear window defogger operates for about 15 minutes and then turns off automatically. The indicator light illuminates when the ...

Mazda 6 Service Manual: Combine sensor removal/installation
Caution Be careful and do not allow the combine sensor to fall. If by chance it is subjected to strong impact, replace it. 1. Remove the center console. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. After installation, perform the comb ...