Mazda 6 Service Manual: Combine sensor removal/installation
Caution
- Be careful and do not allow the combine sensor to fall. If by chance it is subjected to strong impact, replace it.
1. Remove the center console.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. After installation, perform the combine sensor initialization procedure. (See COMBINE SENSOR INITIALIZATION PROCEDURE.)
Dsc hu/cm inspection
1. Remove the battery and battery bracket.
2. Disconnect the DSC HU/CM connector.
3. Connect the SST (49 G066 004) to the DSC HU/CM connector and
harness side connector.
4. Inspect voltage referr ...
Combine sensor inspection
Caution
Be careful and do not allow the lateral-G sensor to fall. If by
chance it is subjected to strong impact, replace it.
1. Connect the connector.
2. Turn ignition switch on, verify the ...
Other materials:
Mazda 6 Service Manual: Cruise Control (Some models)
With cruise control, you can set and automatically maintain any speed of more
than about 25 km/h (16 mph).
WARNING
Do not use the cruise control under the following conditions: Using
the cruise control under the following conditions is dangerous and could result
in loss of vehicle control.
...
Mazda 6 Service Manual: Automatic transaxle fluid (atf) replacement
Warning
When the transaxle and ATF are hot, they can badly burn you. Turn
off the engine and wait until they are cool before changing the ATF.
1. Remove the oil dipstick.
2. Remove the oil drain plug and washer.
3. Drain the ATF into a container.
4. Install a new washer and the drain ...