1. Position the vehicle on level ground.
2. Warm up the engine to normal operating temperature.
3. Stop the engine and wait for 5 min.
4. Remove the dipstick.
5. Verify that the oil level is between the F and L marks on the dipstick and check the engine oil condition.
Engine oil
Engine oil replacementMazda 6 Service Manual: Rear crossmember removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...
Mazda 6 Service Manual: Dtc table
DTCs are common for present and past malfunction diagnosis.
Note
When DTCs not shown in the DTC table are displayed, replace
the SAS unit.
If the air bag system warning light does not illuminate or
remains illuminated when the ignition switch is turned to ON position,
i ...