Mazda 6 Service Manual: Fan motor
COOLING FAN REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the shroud panel. (See SHROUD PANEL REMOVAL/INSTALLATION.)
3. Remove the A/C pipe stay.
4. Remove the ATX pipe stay (ATX).
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
COOLING FAN MOTOR REMOVAL/INSTALLATION
1. Remove the cooling fan. (See COOLING FAN REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
COOLING FAN MOTOR INSPECTION
1. Verify that the battery is fully charged.
2. Connect battery positive voltage and an ammeter to the fan motor connector.
3. Verify that the fan motor operates smoothly at the standard current draw.
- If not as spcifid, replace the fan motor.
Water pump
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) (See
ENGINE COOLANT REPLACEMENT.)
3. Loosen the water pump pulley bolt to remove the d ...
Other materials:
Mazda 6 Service Manual: Snow Tires
Use snow tires on all four wheels
Do not go faster than 120 km/h (75 mph) while driving with snow tires. Inflate
snow tires 30 kPa (0.3 kgf/cm2, 4.3 psi) more than recommended on the tire pressure
label (driver's door frame), but never more than the maximum cold-tire pressure
shown on the tir ...
Mazda 6 Service Manual: Battery Runs Out
Jump-Starting
Jump-starting is dangerous if done incorrectly. So follow the procedure carefully.
If you feel unsure about jump-starting, we strongly recommend that you have a competent
service technician do the work.
WARNING
Follow These Precautions
Carefully: To ensure safe and correct ha ...