Outline
- Provides a quick inspection of the headlight auto leveling system.
- Is usually performed at the start of each deagnostic procedure.
- Provides verification after repairs to ensure that no other faults occurred during service.
(WDS or equivalent).
Read/clear diagnostic results
Reading DTCs Procedure Using WDS or equivalent
1. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector.
2. Retrieve DTC by WDS or equivalent.
Clearing DTCs Procedures Using WDS or equivalent
1. After repairs have been made, perform the DTCs reading procedure.
2. Erase DTC by WDS or equivalent.
3. Ensure that the customer′s concern has been resolved.
Active Command Modes Procedure
1. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector.
2. Turn the ignition switch to ON (Engine OFF) or start engine.
3. Turn on the headlight (low-beam).
4. Activate active command modes using WDS or equivalent.
Mazda 6 Service Manual: Center roof antenna removal/installation
1. Disconnect the negative battery cable.
2. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. After installation, verify that the rubber of the center roof antenna is
installed to the r ...
Mazda 6 Service Manual: Operating Tips for AAC
AAC stands for Advanced Audio Coding, which is standardized voice compression
established by the ISO*1 working group (MPEG). Audio data can be created and stored
at a higher compression ratio than MP3.
This unit plays files with the extensions (.aac/.m4a/.wav) as the AAC files.
*1 Internationa ...