Mazda 6 manuals

Mazda 6 Service Manual: Foreword

Caution

Note

1. Turn the ignition switch to START position for 2 seconds,

then back to ON position.

2. Wait for 1 minute.

3. Verify the security light condition and read the DTC if indicated.

4. Verify the DTC with WDS or equivalent.

5. If the DTC is indicated, go to troubleshooting referring to the DTC table.

On-board diagnostic [immobilizer system]
...

Dtc table
Note Perform the following if the security light stays on: - If gasoline engine stalls, go to symptom troubleshooting NO.11 ENGINE STALLS/QUITS, ENGINE RUNS ROUGH, MISSES, BUCK/JERK, ...

Other materials:

Mazda 6 Service Manual: To Increase Cruising Speed
Follow either of these procedures. To increase speed using cruise control switch Press the RESUME/ switch and hold it. Your vehicle will accelerate. Release the switch at the desired speed. Press the RESUME/ switch and release it immediately to adjust the preset speed. Multiple operations wil ...

Mazda 6 Service Manual: Headlight zeroset
Note When the configuration is not set for the auto leveling control unit, headlight zeroset cannot be executed. 1. Adjust the tire air pressure to the specification. 2. Position the unloaded vehicle on a flat, level surface. 3. Connect the SST (WDS or equivalent) to the DLC-2. 4. Turn t ...

© 2016-2026 Copyright www.mazda6info.net