1. Remove the under cover.
2. Remove the splash shield.
3. Remove the front auto leveling sensor. (See FRONT AUTO LEVELING SENSOR REMOVAL/INSTALLATION.)
4. Remove the transverse member. (See TRANSVERSE MEMBER REMOVAL/INSTALLATION.)
5. Remove the steering gear and linkage, and pipe assembly installation bolts from the front crossmember, then suspend the steering gear and linkage with a cable.
Tightening torque
Steering gear and linkage: 74.4-104.8 N·m {7.857-10.68 kgf·m, 54.88-77.29 ft·lbf}
Pipe assembly: 7.8-10.8 N·m {79.6-110.0 kgf·cm, 69.1-95.5 in·lbf}
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
8. Adjust the headlight zeroset. (See HEADLIGHT ZEROSET.)
9. Inspect the front wheel alignment. (See FRONT WHEEL ALIGNMENT.)
No.1 Engine Mount Center Bolt Removal Note
1. Suspend the engine using the SST
.
2. Remove the No.1 engine mount center bolt.
Crossmember Bracket Removal Note
Warning
1. Support the crossmember component with a jack and remove the nuts.
2. Remove the crossmember bracket.
Front Crossmember Bushing Removal Note
1. Mark the crossmember as shown in the figure (rear upper side only).
2. Remove the bushings using screw driver (-), being care not to damage the front crossmember.
Front Crossmember Bushing Installation Note
1. Set the bushings as shown in the figure.
2. Install the bushing onto the crossmember using the SSTs
.
Mazda 6 Service Manual: Abs (abs/tcs) on-board diagnosis
On-Board Diagnostic (OBD) Test Description
The OBD test inspects the integrity and function of the ABS (ABS/TCS)
and outputs the results when requested by the specific tests.
On-board diagnostic test also:
- Provides a quick inspection of the ABS (ABS/TCS) usually performed at
the ...
Mazda 6 Service Manual: Front/rear abs wheel-speed sensor inspection
Visual Inspection
Remove the wheel and tire, and inspect the sensor for looseness and damage.
Replace the sensor if necessary.
Clearance Inspection
Inspect the clearance between the wheel-speed sensor and the sensor rotor.
Clearance
0.3-1.1 mm {0.012-0.043 in}
Resistance Inspection
...