Mazda 6 Service Manual: Front fog light bulb removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
Caution
- A halogen bulb generates extremely high heat when it is used. If the surface of the bulb is soiled, excessive heat will build up and the lights life will be shortened. When replacing the bulb, hold the metal flange, not the glass.
3. Install in the reverse order of removal.
Front Fog Light Bulb Removal Note
Release the bulb pressing wire to remove the front fog light bulb.
Front fog light aiming
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Seat one person in the drivers seat.
4. Position the vehicle 3 m {10 ft} in front ...
Rear combination light removal/installation
1. Disconnect the negative battery cable.
2. Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse orde ...
Other materials:
Mazda 6 Service Manual: Precautions before welding
Vehicles have various electrical parts. To protect the parts from excessive
current generated when welding, be sure to perform the following procedure.
1. Turn the ignition switch to the LOCK position.
2. Disconnect the battery cables.
3. Securely connect the welding machine to the ground nea ...
Mazda 6 Service Manual: Jack
To remove the jack
1. Lift the trunk mat.
2. Remove the pocket.
3. Turn the wing bolt and jack screw counterclockwise.
To secure the jack
1. Insert the wing bolt into the jack with the jack screw pointing to the front
and turn the wing bolt clockwise to temporarily tighten it.
2. Turn ...