Mazda 6 Service Manual: Front fog light aiming
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Seat one person in the drivers seat.
4. Position the vehicle 3 m {10 ft}
in front of a white screen.
5. While adjusting one fog light, mask the other.
6. Start the engine to charge the battery.
7. Turn the front fog light on.
8. Adjust the front fog light by turning the adjusting screws as shown in the figure. Loosen the screws first, then tighten them.
Note
- If the adjusting screws are tightened first, then loosened, they will continue to loosen when the vehicle is in motion and may cause the front fog lights to become misaligned.
Front side turn light removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal. ...
Front fog light bulb removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
Caution
A halogen bulb generates extremely high heat when it is used. If
the surface of the bulb i ...
Other materials:
Mazda 6 Service Manual: Oil filter
OIL FILTER REPLACEMENT
For Europe (LF and L3 engine models)
Caution
To avoid damage to the oil filter, use only specified oil filter.
1. Remove the oil filter drain plug.
2. Untighten the oil filter cover for 2 turns and drain the engine oil.
Note
Oil could be easily drained when th ...
Mazda 6 Service Manual: Settings
NOTE
Depending on the grade and specification, the screen display may differ.
Select the icon on the home
screen and display the Settings screen.
Switch the tab and select the setting item you want to change.
You can customize settings in the setup display as follows:
...