PRECAUTION (SUSPENSION)
Wheels and Tires Removal/Installation
When a wheel is installed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.
Suspension Links Removal/Installation
Tighten any part of the suspension that uses rubber bushings only after the vehicle has been lowered and unloaded.
Note
Brake Lines Disconnection/Connection
Caution
1. Tighten the brake pipe flare nut using the SST
(49 0259 770B). Be sure to modify the brake pipe flare nut tightening torque to allow for use of a torque wrench-SST
combination. (See TORQUE FORMULAS.)
2. If any brake line has been disconnected anytime during the procedure, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.
Power Steering Components Removal/Installation
If any power steering fluid line has been disconnected anytime during the procedure, add ATF M-III
or equivalent (e.g. Dexron®II
), bleed the fluid line, and inspect for leakage after the procedure has been completed.
Mazda 6 Service Manual: Starting a Flooded Engine
If the engine fails to start, it may be flooded (excessive fuel in the engine).
Follow this procedure:
1. If the engine does not start within five seconds on the first try, wait ten
seconds and try again.
2. Make sure the parking brake is on.
3. Depress the accelerator all the way and hold it ...
Mazda 6 Service Manual: Manual transaxle removal/installation
1. Remove the battery, battery tray and battery bracket.
2. Remove the air cleaner compornent. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
3. Remove the wheels, tires and splash shields.
4. Remove the under cover.
5. Remove the steering gear and power steering pipe. (See STEERING GEAR AND
...