Low-beam
Halogen type
1. Disconnect the negative battery cable.
2. Disconnect the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
Caution
4. Install in the reverse order of removal.
Headlight bulb removal note
1. Release the bulb pressing wire to remove the headlight bulb.
Discharge type
Caution
1. Disconnect the negative battery cable.
2. Disconnect the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
Caution
4. Install in the reverse order of removal.
High-beam
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
Caution
3. Install in the reverse order of removal.
Headlight bulb removal note
Release the bulb pressing wire to remove the headlight bulb.
Mazda 6 Service Manual: Rear washer hose removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the clips.
5. Remove rear washer hose No.1 and joint pipe A.
6. Remove the A-pillar trim. (See A-PIL ...
Mazda 6 Service Manual: Rocking the Vehicle
WARNING
Do not spin the wheels at more than 56 km/h (35 mph), and do not allow
anyone to stand behind a wheel when pushing the vehicle: When the vehicle
is stuck, spinning the wheels at high speed is dangerous. The spinning tire could
overheat and explode. This could cause serious injuries.
...