Mazda 6 manuals

Mazda 6 Service Manual: Discharge headlight control unit removal/installation

Mazda 6 Service Manual / Body electrical system / Exterior lighting system / Discharge headlight control unit removal/installation

Caution

1. Configurate the discharge headlight control unit (when only replacing it). (See AUTO LEVELING CONTROL UNIT CONFIGURATION)

2. Disconnect the negative battery cable.

3. Remove the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION)

4. Remove in the order indicated in the table.



5. Install in the reverse order of removal.

6. Perform the headlight zeroset for the discharge headlight control unit (when only replacing it). (See HEADLIGHT ZEROSET)

Headlight bulb removal/installation
Low-beam Halogen type 1. Disconnect the negative battery cable. 2. Disconnect the front combination light. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION) 3. Remove in the order indicated in ...

Auto leveling control unit configuration
1. Connect the SST (WDS or equivalent) to the DLC-2. 2. Input vehicle information following the directions on the screen. 3. Select Module programming. 4. Select Programmable module installation. ...

Other materials:

Mazda 6 Service Manual: Emission Control System
This vehicle is equipped with an emission control system (the catalytic converter is part of this system) that enables the vehicle to comply with existing exhaust emissions requirements. WARNING Never park over or near anything flammable: Parking over or near anything flammable, such as dry ...

Mazda 6 Service Manual: If You Must Use the Front Seat for Children
If you cannot put all children in the rear seat, at least put the smallest children in the rear and be sure the largest child up front uses the shoulder belt over the shoulder. NEVER put a rear-facing child-restraint system on the front passenger seat whether your vehicle is equipped with a o ...

© 2016-2024 Copyright www.mazda6info.net