Mazda 6 Service Manual: Auto leveling control unit configuration
1. Connect the SST
(WDS or equivalent) to the DLC-2.
2. Input vehicle information following the directions on the screen.
3. Select Module programming.
4. Select Programmable module installation.
5. When performing configuration corresponding to each auto leveling control unit, select the following items and perform procedures according to directions on the screen.
Items
- Main: LHID
- Sub: RHID
6. Retrieve DTCs by the WDS or equivalent, then verify that there is no DTC present.
- If DTC is present, perform applicable DTC inspection.
Discharge headlight control unit removal/installation
Caution
Incorrect servicing of the discharge headlight control unit could
result in electrical shock. Before servicing the discharge headlight control
unit, always refer to the Discharge hea ...
Headlight zeroset
Note
When the configuration is not set for the auto leveling control unit,
headlight zeroset cannot be executed.
1. Adjust the tire air pressure to the specification.
2. Position the unloade ...
Other materials:
Mazda 6 Service Manual: Battery
WARNING
Wash hands after handling the battery and related accessories: Battery
posts, terminals and related accessories contain lead and lead compounds, chemicals
known to the State of California to cause cancer and reproductive harm.
Read the following precautions
carefully before using th ...
Mazda 6 Service Manual: Replacing Interior Light Bulbs
Overhead lights/Front map lights (LED type), Rear map lights (LED type)
The LED bulb cannot be replaced as a single unit because it is an integrated
unit. The LED bulb has to be replaced with the unit. We recommend an Authorized
Mazda Dealer when the replacement is necessary.
Overhead lights/F ...