Note
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Connect the SST (WDS or equivalent) to the DLC-2.
4. Turn the ignition switch to ON position.
5. Turn on the headlights (low-beam).
6. Input the vehicle information following the directions on the screen.
7. Confirm that the WDS or equivalent identifies the vehicle, and select Datelogger.
8. After the screen appears, select LHID under Modules from the cascading menu.
9. After the next screen appears, select CALAXLSN#.
10. On the graphic display that appears, press the icon near the top right of the screen indicated by a 1 in the figure.
11. After the next screen appears, press the icon indicated by a 2 in the figure.
12. After pressing the icon indicated by the 2, press the icon indicated by a 3 or 4 in the figure to execute the zeroset setting.
Note
13. After executing the headlight zeroset setting, perform an on-board diagnostic test and verify that no DTCs are displayed.
14. Perform the headlight aiming adjustment. (See HEADLIGHT AIMING)
Mazda 6 Service Manual: Wiper Blades
CAUTION
Hot waxes applied by automatic car washers have been known to affect
the wiper's ability to clean windows.
To prevent damage to the wiper blades, do not use gasoline, kerosene,
paint thinner, or other solvents on or near them.
When the wiper lever is in the AUTO position and th ...
Mazda 6 Service Manual: Front passenger air bag deactivation indicator light
This indicator light turns on to remind you that the front passenger front and side air bags and seat belt pretensioner will not deploy during a collision.
If the front passenger occupant classification sensor is normal, the indicator light turns on when the ignition is switched ON. The ...