Mazda 6 Owners Manual: Replacing Interior Light Bulbs
Overhead lights/Front map lights (LED type), Rear map lights (LED type)
The LED bulb cannot be replaced as a single unit because it is an integrated unit. The LED bulb has to be replaced with the unit. We recommend an Authorized Mazda Dealer when the replacement is necessary.
Overhead lights/Front map lights (Bulb type), Rear map lights (Bulb type), Vanity mirror lights (Some models), Courtesy lights
1. Wrap a small flathead screwdriver with a soft cloth to prevent damage to the lens, and then remove the lens by carefully prying on the edge of the lens with the flathead screwdriver.
2. Disconnect the bulb by pulling it out.
Overhead lights/Front map lights
Rear map lights
Vanity mirror lights (Some models)
Courtesy lights
3. Install the new bulb in the reverse order of the removal procedure.
Trunk light
1. Press both sides of the lens cap to remove it.
2. Disconnect the bulb by pulling it out.
3. Install the new bulb in the reverse order of the removal procedure.
Replacing Exterior Light Bulbs
Headlights (With LED headlights)
Low/High beam bulbs
The LED bulb cannot be replaced as a single unit because it is an integrated
unit.
The LED bulb has to be replaced with the unit. We recommend ...
Fuses
Your vehicle's electrical system is protected by fuses.
If any lights, accessories, or controls do not work, inspect the appropriate
circuit protector. If a fuse has blown, the inside element will ...
Other materials:
Mazda 6 Owners Manual: Jam-safe Moonroof
If a person's hands, head or an object blocks the moonroof while it is closing,
the moonroof will stop and move in the reverse direction.
WARNING
Make sure nothing blocks the moonroof just before it reaches the fully closed
position: Blocking the moonroof just before it reaches the closed posi ...
Mazda 6 Owners Manual: Pcm inspection
Note
PIDs for the following parts are not available on this model. Go
to the appropriate part inspection page.
- CMP sensor (See CAMSHAFT POSITION (CMP) SENSOR INSPECTION.)
- Main relay (See RELAY INSPECTION.)
1. Connect the SST (WDS or equivalent) to the DLC-2.
2. Turn the igni ...