Note
1. Drive the vehicle at 30 km/h {19 mph} or more.
2. Press on the cruise control main switch (1).
3. Operate each of the cruise control switches.
4. Stop the vehicle and let it idle.
5. Turn and hold the RESUME/ACCEL switch on for at least 3 seconds (2).
The cruise set indicator light will illuminate for 3 seconds,
and then go off for at least 2 seconds.
Thus, the condition detection mode begins.
6. The condition detection mode is canceled by turning the ignition switch to LOCK position or turning off the cruise control main switch.
Condition Code List
Note
Inspection of Diagnostic Trouble Codes
Foreword
Mazda 6 Service Manual: Dtc table
Note
Perform the following if the security light stays on:
- If gasoline engine stalls, go to symptom troubleshooting NO.11
ENGINE STALLS/QUITS, ENGINE RUNS ROUGH, MISSES, BUCK/JERK,
HESITATION/STUMBLE, SURGES in. (See NO.11 ENGINE STALLS/QUITS, ENGINE RUNS
ROUGH, MISSES, BUCK/J ...
Mazda 6 Service Manual: Transaxle range (tr) switch inspection
Operating Inspection
1. Verify that the starter operates only when the ignition switch is at the
START position with the selector lever in P or N position.
If not as specified, adjust the TR switch.
2. Verify that the back-up lights illuminate when shifted to R position with
the ignition ...