Note
- Cruise actuator ignition power supply fuse
- Cruise set indicator light power supply fuse
- Cruise control switch
- Cruise control main switch
- Clock spring for air bag system
- Print plate in instrument cluster
- Cruise set indicator light bulb
- Cruise actuator
- Open or short circuit in following wiring harnesses:
- Between cruise set indicator light and cruise actuator terminal G
- Between fuse block and cruise actuator terminal L
- Between fuse block and instrument cluster
- Between cruise actuator and clock spring
- Between clock spring and cruise control switch
- Open circuit in following wiring harnesses:
- Between cruise actuator terminal I and ground
- Between clock spring and ground
1. Turn the ignition switch to the ON position.
2. Verify that the cruise control main switch is off.
3. Press and hold the RESUME/ACCEL switch on (1), and turn on the cruise control main switch (2). Keep the RESUME/ACCEL switch on for 3 seconds or more
after the cruise control main switch released. (The cruise set indicator light will illuminate for 3 seconds,
showing that the system inspection has started.)
4. Operate each switch as described in the operation code list and note the operation code list pattern.
5. The operation mode is canceled by turning the ignition switch to LOCK position or turning off the cruise control main switch.
Operation Code List
Inspection of Diagnostic Trouble Codes
Foreword
Mazda 6 Service Manual: Seat Operation
1. Seat Slide
(Manual Seat)
To move a seat forward or backward, raise the lever and slide the seat to the
desired position and release the lever.
Make sure the lever returns to its original position and the seat is locked in
place by attempting to push it forward and backward.
(Power Seat) ...
Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire
A jumper wire is used to create a temporary circuit. Connect the jumper
wire between the terminals of a circuit to bypass a switch.
Caution
Do not connect a jumper wire from the power source line to a body
ground. This may cause burning or other damage to wiring harnesse ...