Mazda 6 Service Manual: Instrument cluster removal/installation
Caution
- When replacing the instrument cluster, the configuration procedure must be performed before removing the instrument cluster. If the configuration procedure is not performed before removing the instrument cluster, it is possible that the instrument cluster will not operate normally.
1. Configurate the instrument cluter (when only replacing it). (See INSTRUMENT CLUSTER CONFIGURATION.)
2. Disconnect the negative battery cable.
3. Pull down the adjusting lever of the tilt steering wheel and push the steering wheel down.
4. Pull the steering wheel toward you.
5. Remove the meter hood.
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
Instrument Cluster Removal Note
When removing the instrument cluster, in order to prevent damage to the lens, cover the steering shaft with a cloth.
Instrument cluster configuration
1. Connect the SST (WDS or equivalent) to the DLC-2.
2. Input vehicle information following the directions on the screen.
3. Select Module programming.
4. Select Programmable module installation. ...
Other materials:
Mazda 6 Service Manual: Front fog light bulb removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
Caution
A halogen bulb generates extremely high heat when it is used. If
the surface of the bulb is soiled, excessive heat will build up and the
lights life will be shortened. When replacing the ...
Mazda 6 Service Manual: New standards
Following is a comparison of the previous standard and the new standard.
#1 : Diagnostic trouble codes depend on the diagnostic test mode
#2 : Controlled by the PCM
#3 : In some models, there is a fuel pump relay that controls pump speed.
That relay is now called the fuel pump relay (s ...