Note
Resistance Inspection
1. Turn the ignition switch to LOCK.
2. Disconnect the knock sensor connector.
3. Measure the resistance between the knock sensor terminals A and B using an ohmmeter.
Specification
Approx. 4.87 megohms
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harnesses for open or short. (Continuity check)
Open circuit
- Knock sensor terminal A (harness-side) and PCM terminal 2S (harness-side)
- Knock sensor terminal B (harness-side) and PCM terminal 2P (harness-side)
Short circuit
- Knock sensor terminal A (harness-side) and power supply
- Knock sensor terminal A (harness-side) and body GND
- Knock sensor terminal B (harness-side) and power supply
- Knock sensor terminal B (harness-side) and body GND
Mazda 6 Service Manual: Transaxle Ranges
The shift position indicator light in the instrument cluster illuminates.
The selector lever must be in P or N to operate the starter.
P (Park)
P locks the transaxle and prevents the front wheels from rotating.
WARNING
Always set the selector lever to P and set the parking brake:
Only s ...
Mazda 6 Service Manual: Rear door unit removal/installation
1. Remove the rear door glass.
2. Remove the inner handle.
3. Remove the rear door speaker.
4. Disconnect the power window motor connector, and power door lock actuator
connector.
5. Remove the rear door harness from the rear door unit.
6. Remove the bolts.
7. Remove the rear door lock act ...