Mazda 6 Service Manual: Light switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Steering angle sensor inspection
With DSC
1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
2. Disconnect the steering angle sensor connector.
3. Connect battery positive voltage to terminal A and ground to termi ...
Light switch inspection
Light switch LH side
1. Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION)
2. Inspect for continuity between the light switch terminals using an
ohmmeter.
If not as specified, re ...
Other materials:
Mazda 6 Service Manual: Engine Coolant Temperature Gauge (Without Multi-information Display)
Displays the engine coolant temperature. The white gauge indicates that the engine
coolant temperature is low, and the red gauge indicates that the engine coolant
temperature is high and overheating.
CAUTION
If the engine coolant temperature gauge indicator flashes, there is a possibility
...
Mazda 6 Service Manual: Obd drive mode
Performing the Drive Mode inspects the OBD system for proper operation.
The Drive Mode must be performed to ensure that no additional DTCs are
present.
During Drive Mode, the following systems are inspected:
- Oxygen sensor (HO2S)
- Oxygen sensor heater
- Catalytic converter (TW ...