With DSC
1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
2. Disconnect the steering angle sensor connector.
3. Connect battery positive voltage to terminal A and ground to terminal F of the steering angle sensor.
4. Turn the steering wheel to the right and left, and verify that the voltage and pulses at the terminals are as shown in the figure.
Mazda 6 Service Manual: No.1 abs warning light, brake system warning light, tcs off light do not
illuminate with ignition switch on
Vehicle with ABS/TCS
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure conn ...
Mazda 6 Service Manual: i-ELOOP
i-ELOOP is a regenerative braking system. When you depress the brake pedal or
use engine braking, the kinetic energy that occurs is converted to electrical energy
by the power generator and the converted electrical energy is stored in the rechargeable
battery (capacitor and battery). The store ...