Mazda 6 Service Manual: No.1 while vehicle is in reverse, vehicle locator mark goes forward

Mazda 6 Service Manual / Body electrical system / Troubleshooting / No.1 while vehicle is in reverse, vehicle locator mark goes forward

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiring harness are connected correctly and undamaged.

Diagnostic procedure

Car-navigation system

Troubleshooting Index Use the chart below verify the trouble in order to diagnose the appropriate area. ...

No.2 in navigation mode, vehicle locator mark skips

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Operation
NOTE The engine may not start and security indicator light may illuminate or flash if the key is placed in an area where it is difficult for the system to detect the signal, such as on the dashboard or in the glove compartment. Move the key to a location within the signal range, switch ...

Mazda 6 Service Manual: No.9 noise while operating a/c system
Diagnostic procedure * : If there is gas leakage, air enters into the A/C system. The desiccant within the receiver/drier absorbs the moisture from the air and becomes saturated. If the A/C system is used in this condition, the inside of the A/C compressor will begin to rust due to this ...