If the battery is disconnected, the moonroof will not operate. The moonroof will not operate correctly until it is reset.
Carry out the following procedure to reset the moonroof and resume operation:
1. Switch the ignition ON.
2. Press the tilt switch, to partially tilt open the rear of the moonroof.
3. Repeat Step 2. The rear of the moonroof tilts open to the fully open position, then closes a little.
NOTE
If the reset procedure is performed while the moonroof is in the slide position (partially open) it will close before the rear tilt opens.
Mazda 6 Owners Manual: Seat warmer unit inspection
1. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.)
2. Remove the seat cushion trim.
3. While inspecting for continuity between the terminals A and B of the
connector, use a dryer to warm the thermostat of the seat warmer unit on seat
cushion.
4. When the indication on the ohmm ...
Mazda 6 Owners Manual: Forward Sensing Camera (FSC) (Some models)
Your vehicle is equipped with a Forward Sensing Camera (FSC). The Forward Sensing
Camera (FSC) is positioned near the rearview mirror and used by the following systems.
High Beam Control System (HBC)
Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS)
Traffic Sign Reco ...