Mazda 6 Service Manual: Seat warmer unit inspection
1. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.)
2. Remove the seat cushion trim.
3. While inspecting for continuity between the terminals A and B of the connector, use a dryer to warm the thermostat of the seat warmer unit on seat cushion.
4. When the indication on the ohmmeter is no continuity, turn off the dryer, then use a thermometer to measure the temperature of the thermostat.
5. Verify that the temperature is approximately 29 °C {84 °F}.
6. Verify that there is continuity between the terminals of seat warmer units connector using an ohmmeter when temperature drops to approximately 20 °C {68 °F}.
Seat warmer switch inspection
1. Remove the seat warmer switch.
2. Inspect for continuity between the seat warmer switch terminals using an
ohmmeter.
If not as specified, replace the seat warmer switch.
Drivers side
...
Body shell
...
Other materials:
Mazda 6 Service Manual: Customer Assistance (Puerto Rico)
Your complete and permanent satisfaction is our business. That is why all Authorized
Mazda Dealers have the knowledge and the tools to keep your Mazda vehicle in top
condition. If you have any questions or recommendations for improvement regarding
the service of your Mazda vehicle or servicing ...
Mazda 6 Service Manual: Front door trim removal/installation
1. Disconnect the negative battery cable.
2. Open the cap using a small screwdriver, then remove the screw.
3. Remove the inner handle cover.
4. Remove the inner garnish.
5. Remove the cover, then remove screw A.
6. Remove the lens cover, then remove screw B.
7. Disengage clips A from the ...