Mazda 6 Service Manual: Body

Rear crossmember removal/installation

Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing ...

Location index

...

Other materials:

Mazda 6 Service Manual: Drive shaft (mtx) disassembly/assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. Clip Disassembly Note 1. Mark the drive shaft and outer ring for proper assembly. Caution Mark with paint; do not use a punch. 2. Remove the clip. Balls, Inner Ring, Cage Disassembl ...

Mazda 6 Service Manual: Evaporator temperature sensor inspection
1. Turn the AUTO switch on. 2. Set the temperature control at MAX COLD (Turn the left). 3. Turn the A/C switch. 4. Set the RECIRCULATE mode. 5. Close all doors and windows. 6. Wait for 5 minutes. 7. Remove the glove compartment. 8. Disconnect the evaporator temperature sensor. 9. Measure t ...