Mazda 6 Service Manual: Front outer handle removal/installation
1. Remove the front door glass.
2. Detach the outer handle and front door latch rod.
3. For protector-equipped vehicles, refer to key cylinder removal/installation to remove the protector.
4. Remove the bolts.
5. With the rear side of the outer handle fixed and the outer handle lever pulled out (1), remove the rear side of the outer handle from the front door.
6. Pull out the front side of the outer handle from the front door.
7. Install in the reverse order of removal.
Front door key cylinder removal/installation
1. Remove the front door unit.
2. Remove the cover, then remove the bolt.
3. For protector-equipped vehicles, pull out the protector tab from the latch
and remove the protector.
4. Disconnect ...
Rear outer handle removal/installation
1. Remove the rear door glass.
2. Remove the rear door unit.
3. Remove the rear door latch.
4. Remove the bolts.
5. Detach the rear outer handle and rear door latch rod.
6. With the rear side o ...
Other materials:
Mazda 6 Service Manual: Opening the Hood
1. With the vehicle parked, pull the release handle to unlock the hood.
2. Insert your hand into the hood opening, slide the latch lever to the right,
and lift up the hood.
NOTE
The lever is located a little to the left of center when facing the vehicle.
3. Grasp the support rod in the pad ...
Mazda 6 Service Manual: Filament inspection
1. Turn the ignition switch to ON position.
2. Turn the rear window defroster switch on.
Caution
Directly touching the rear window defroster filament with the lead
of the voltmeter will damage it. Wrap aluminum foil around the end of the
lead and test the filament by touching it with the ...