Mazda 6 Service Manual: Sunroof motor installation
1. Connect the sunroof motor connector.
2. Connect the sunroof switch connector.
3. Connect the negative battery cable.
4. Turn the ignition switch to ON position.
5. Press the CLOSE side of the slide switch until the sunroof motor stops.
6. Disconnect the sunroof switch connector.
7. Install the screws, and then install the sunroof motor.
8. Install the headliner.
Sunroof motor removal
1. Disconnect the negative battery cable.
2. Remove the headliner.
3. Disconnect the connector.
4. Remove the screws, and then remove the sunroof motor.
...
Sunroof motor inspection
Motor
1. Remove the sunroof motor.
2. Apply battery positive voltage to the sunroof motor terminals and inspect
the operation of the sunroof motor.
If not as specified, replace the sunroof mot ...
Other materials:
Mazda 6 Service Manual: Operating Tips for USB device
This unit plays audio files as follows:
CAUTION
Do not use an audio file extension on files other than audio files. In addition,
do not change the audio file extension. Otherwise, the unit will not recognize the
file correctly resulting in noise or a malfunction.
NOTE
Playback may not b ...
Mazda 6 Service Manual: Troubleshooting procedure
Basic flow of troubleshooting
DTC troubleshooting flow (on-board diagnostic)
Diagnostic trouble codes (DTCs) are important hints for repairing
malfunctions that are difficult to simulate.
Perform the specific DTC diagnostic inspection to quickly and accurately
diagnose the malfunction.
The ...